Dell S5000 Getting Started Manual page 33

– port range: 0
2. Assign an IP address to the interface.
INTERFACE mode
ip address ip-address/mask
– ip-address: an address in dotted-decimal format (A.B.C.D).
– mask: a subnet mask in /prefix-length format (/ xx).
3. Enable the interface.
INTERFACE mode
no shutdown
Configuring a Management Route
Define a path from the system to the network from which you are accessing the system remotely. Management routes
are separate from IP routes and are only used to manage the system through the management port.
• Configure a management route to the network from which you are accessing the system.
CONFIGURATION mode
management route ip-address/mask gateway
– ip-address: the network address in dotted-decimal format (A.B.C.D).
– mask: a subnet mask in /prefix-length format (/ xx).
– gateway: the next hop for network traffic originating from the management port.
Configuring a Username and Password
• Configure a username and password to access the system remotely.
CONFIGURATION mode
username username password [encryption-type]
encryption-type specifies how you are inputting the password, is 0 by default, and is not required.
– 0 is for inputting the password in clear text.
– 7 is for inputting a password that is already encrypted using a Type 7 hash. Obtaining the encrypted
password from the configuration of another Dell Networking system.
Creating a Port-based VLAN
The default virtual local area network (VLAN) (VLAN 1) is part of the system startup configuration and does not require
configuration.
To configure a port-based VLAN, create the VLAN and then add physical interfaces or port channel (LAG) interfaces to
the VLAN.
• Configure a port-based VLAN (if the VLAN-ID is different from the Default VLAN ID) and enter INTERFACE VLAN
mode.
CONFIGURATION mode
interface vlan vlan-id
After you create a VLAN, you must assign interfaces in Layer 2 mode to the VLAN to activate the VLAN.
To view the configured VLANs, use the show vlan command in EXEC Privilege mode.
33