Tip
•
You can optimize the audio output (see chapter 'Adjust
settings' - [ Audio Setup ] > [ Digital Audio ]) for details.
Connect to analog stereo system
1
Connect the audio cables (supplied) to the
AUDIO OUT L/R jacks on this DVD player and
the audio input jacks on the device.
Tip
•
You can optimize the audio output (see chapter 'Adjust
settings' - [ Audio Setup ] > [ Analog Output ]) for
details.
Connect USB device
1
Connect the USB fl ash drive to the
jack on this DVD player.
Note
•
This DVD player can only play/view MP3, WMA, DivX or
JPEG fi les that are stored on such devices.
•
to access the content and play the fi les
Press
8
EN
AUDIO IN
(USB)
.
Connect to power outlet
Warning
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the DVD player.
1
Connect the power cord to the power outlet.
The DVD player is ready to be set up for
use.
4
Get started
Prepare the remote control
1
Push to open the battery compartment cover.
2
Insert two R03 or AAA batteries type with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Caution
•
Remove batteries if they are exhausted or if the remote
control is not to be used for a long time.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
•
Batteries contain chemical substances, they should be
disposed off properly.
Navigate through the menu
1
Point the remote control directly at the remote
sensor on this DVD player and select the
desired function.