Table of Contents
Advertisement
Note
•
If a blank/distorted screen is displayed, wait for 15
seconds for the auto recover.
•
If no picture displayed, turn off the progressive scan
mode as follows:
1) Press Z to open the disc compartment.
2) Press the
numeric button '1'
6
To exit the menu, press SETUP.
7
You can now turn on the progressive scan
mode on the TV (see the TV user manual).
Note
•
The progressive scan setting will not be available when
the HDMI video signal is detected.
•
During play, when progressive scan mode is on for both
this DVD player and the TV, distorted picture may
display. Turn off the progressive scan feature on both this
DVD player and the TV.
Use Philips EasyLink
The DVD player supports Philips EasyLink, which uses
the HDMI CEC (Consumer Electronics Control)
protocol. EasyLink-compliant devices that are
connected through HDMI connectors can be
controlled by a single remote control.
Philips does not guarantee 100% interoperability with
all HDMI CEC devices.
1
Turn on the HDMI CEC operations on the TV
and other connected devices. See TVs/devices
manual for details.
2
You can now enjoy the following Philips
EasyLink controls.
One-touch play
When you press the
the TV and this DVD player, then video disc play
starts.
•
To enable One-touch play, a video disc must be
placed in the disc compartment before operation.
One-touch standby
When you press and hold the STANDBY button, all
connected HDMI CEC devices switch to standby
mode simultaneously.
Tip
•
The default setting for EasyLink features is on. You can
change the default setting, see chapter 'Adjust settings' -
[ Video Setup ]
[ HDMI Setup ]
>
] for details.
10
EN
.
button, it turns on
STANDBY
> [ EasyLink Setup
5
Play
Play from disc
Note
•
DVDs and DVD players are designed with regional
restrictions. Ensure that the DVD video you play is for
the same region zone as the player (indicated on its
back).
•
This DVD player can support play of the following fi le
formats: MP3/WMA/JPEG/DivX.
•
To play DVD-R, DVD+R or DVD-RW, the disc must be
fi nalized.
Play a disc
Caution
•
Never place any objects other than discs into the disc
compartment.
Press Z to open the disc compartment.
1
2
Insert a disc with its label facing up.
•
For double-sided disc, load the side to play
faces up.
Press Z to close the disc compartment and
3
start disc play.
•
To view disc play, turn on the TV to the
correct viewing channel for this DVD player.
To stop disc play, press x.
4
Tip
•
If the password entry menu is displayed, you have to
enter the password before it can be played.
•
If you pause or stop a disc for about 5 minutes, the
screen saver activates. To deactivate the screen saver,
DISC MENU.
press
•
After you pause or stop a disc, if no buttons are pressed
within 15 minutes, this DVD player automatically
switches to standby mode.
Play video
Note
•
For video disc, play always resumes from the point where
it was last stopped. To start play from the beginning,
í
press
while the message is displayed.
Advertisement
Table of Contents
