Leica DISTO D510 How To Use Manual page 7

* Once the device is switched off, reference goes back to standard setting (i.e. rear of the
device)
Adjusting/Standardising/Calibration of tilt sensor (Tilt
Calibration)
 Press the
 Select the Settings option from this screen by pressing the soft key
 On this screen, Tilt calibration icon
 Navigate to the
* Press to exit settings.
(Also)
Follow these quick 6 steps to adjust or calibrate your device in case of an unlikely
discrepancy.
As indicated on the device display:

Place the device on an absolute flat surface with its display up and press

Next rotate it by 180° and place the device on the surface as it was and press

Next stand the device up on a horizontal surface and press

As indicated rotate the device 18o°in its vertical position and press

Next place the device upside down as shown in the picture on the left and press

Rotate the device again by 180° and place it on the surface and press
*
The device calibration is complete.
from the front,
back,
middle or
tripod thread of the device.
key once to reach the application screen.
underneath the icon
the display.
icon using
Select the icon using
.
is located at the bottom left of
keys to select for Tilt calibration.
=
key.
.
.
again.
again.
.
.