Leica DISTO D810 touch Firmware Update

Hide thumbs Also See for DISTO D810 touch:

Download this manual

Update Firmware V 1705

Precondition: You need Leica DISTO

Leica DISTO

D810 touch

D810 touch, USB cable and a Windows PC.

1. Download program

from webpage:

http://ptd.leica-

geosystems.com/en/Softw

are-Leica-DISTO-D810-

touch_104999.htm

2. Execute the update

program in order to install

and follow instructions.

3. Start update program

on PC.

4. Press button ON DIST

to switch on device.

5. Press six buttons in the

same order as shown in

picture.

Page 1 Update Firmware V 1705 Precondition: You need Leica DISTO D810 touch, USB cable and a Windows PC. 1. Download program from webpage: http://ptd.leica- geosystems.com/en/Softw are-Leica-DISTO-D810- touch_104999.htm 2. Execute the update program in order to install and follow instructions. 3. Start update program on PC.
Page 2 7. Press key Down navigation to select entry USB RNDIS. 8. Press selection key below green tackle to confirm. 9. Press button C/OFF for two seconds to switch off device. Leica DISTO D810 touch...
Page 3 Note! Do not disconnect device from laptop/PC during update process! An Error Message 5056 may shortly appear on DISTO™ display during installation. 14. If the installation has been successful the message “success” and a green tackle appears on screen. Leica DISTO D810 touch...