Husqvarna AUTOMOWER 535 AWD Operator's Manual page 46

Message Cause
Connectivity prob-
Problem with the Automower
lem
module.
Outside work area The boundary wire connections to the
charging station are crossed.
The boundary wire is too close to the
edge of the work area.
The work area slopes too much by the
boundary loop.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.
Limited cutting The cutting height adjustment cannot
height
move.
Unexpected cut-
ting height
Cutting height
problem, drive
Cutting height
blocked
Cutting height
problem
No power in charg-
Wrong or faulty power supply unit.
ing station
Power failure.
No contact between the contact plates
and the charging plates.
Cutting system im-
Too few or too many blades.
balance
46 - Troubleshooting
Action
®
Connect Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Make sure that the boundary wire is
connected correctly. Refer to
ine where to put the boundary wire on
page 17 .
Make sure that the boundary wire has
been laid according to the instructions.
To install the boundary wire on
Refer to
page 23 .
Move the boundary wire and/or make
more islands in the work area to in-
crease the signal strength.
Put the product in the charging station
and generate a new loop signal. Refer
To create a New loop signal on page
to
31 .
Examine the cutting height adjustment
and remove grass and other unwanted
material. If the problem remains, the
message requires action by authorized
service technician.
Examine the power supply. If it is nec-
essary, replace the power supply.
Find and rectify the cause of the power
failure.
Make sure that the charging plates and
the contact plates are connected.
Examine the blades on the blade disc.
To exam-
1427 - 002 - 20.12.2019