Information Messages - Husqvarna AUTOMOWER 535 AWD Operator's Manual

6.3 Information messages

The table below shows a number of information messages that may be shown in Automower
Connect. Contact your local Husqvarna representative if the same message appears often. For more
Messages on page 31 .
information, refer to
Message Cause
Low battery
The product cannot find the charging
station.
The battery is spent.
The charging station's antenna is de-
fective.
Settings restored
Confirmation that
tings has been carried out.
Guide 1/2/3 not
The guide wire is not connected to the
found
charging station.
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
Connection
New loop signal successfully changed.
changed
Connection NOT
Failed to change the loop signal.
changed
Slope too steep
The product stopped mowing because
the slope is too steep.
48 - Troubleshooting
Action
Change the position of the guide wire.
Refer to
page 23 .
Make sure that the charging station is
installed correctly. Refer to
charging station on page 28 .
Replace the battery. Refer to
on page 39 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 49 . This problem requires ac-
tion by authorized service technician.
Reset all user set-
This is normal. No action required.
Check that the guide wire's connector
is tightly connected to the charging sta-
tion. Refer to
on page 23 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 23 .
No action.
Create a new loop signal, try several
times. If the problem remains, the mes-
sage requires action by authorized
service technician. Refer to
New loop signal on page 31 .
If this problem occurs frequently,
change the installation of the boundary
wire to exclude the steep part of the
work area.
®
To install the guide wire on
To find the
Battery
To install the guide wire
To create a
1427 - 002 - 20.12.2019