Husqvarna AUTOMOWER 535 AWD Operator's Manual page 31

To create a New loop signal
1. Put the product in the charging station.
Settings > Security > New loop signal
2. Select
in the app.
Create new loop signal .
3. Select
Save .
4. Select
5. Wait for confirmation that the loop signal has
been generated. This usually takes about 10
seconds.
3.12.6.2 To change the PIN code
Settings > Security > Change PIN
1. Select
code in the app.
2. Enter the PIN code.
3. Enter the new PIN code.
4. Enter the new PIN code to confirm.
5. Make a note of the new PIN code in Memo.
Introduction on page 3 .
Refer to
3.12.6.3 Theft protection
Theft protection menu it is possible to set
In the
the alarm duration and also what events should
trigger the alarm. The factory setting is to require
PIN code and the alarm duration is 1 min.
Alarm duration
There is a possibility to set how long the alarm
signal should last. A setting between 1 and 10
minutes is possible.
STOP button pressed
"STOP button pressed" is enabled,
If the alarm
the alarm goes off if someone presses the STOP
button and the PIN code is not entered within 30
seconds.
Carried away
Carried away is enabled, the product
If the alarm
senses unexpected motions, and the alarm goes
off.
To set the Theft protection
Settings > Security > Theft protection
1. Select
in the app.
2. Select the on/off button to enable or disable
STOP button pressed and Carried away .
the
3. Move the horizontal bar to select the
duration of the alarm.
3.12.6.4 GeoFence
GeoFence is a GPS-based theft protection that
makes a virtual fence for the product. If the
1427 - 002 - 20.12.2019
product is more than 500 m / 1650 ft away from
the center position the product will be deactivated
and an alarm will start. The PIN code is needed
to deactivate the alarm and to start the product
again.
To set the center position for the GeoFence
function
Settings > Security > GeoFence in
1. Select
the app.
2. Put the product in a central position of the
work area.
3. Select the on/off button to enable or disable
the GeoFence function. The center position
will be set to the current position of the
product.
®
3.12.7 Automower Connect (Bluetooth
only)
®
Automower
In
enable or disable the Automower
Connect module. You can also see the
signal strength, connectivity status,
initiate new pairing or remove the
product from the paired accounts.
3.12.8 Messages
In this menu the previous fault and information
messages can be found. For some of the
messages, there are tips and advice to help to
rectify the fault.
If the product is disrupted in any way, for
example it is trapped or the battery is low, a
message is saved relating to the disruption and
the time it happened.
If the same message is repeated several times,
this may indicate that an adjustment to the
installation or the product is required. Refer to
Installation on page 16 .
®
Connect you can
®
Installation - 31