Husqvarna AUTOMOWER 535 AWD Operator's Manual page 30

product moves back into the work area. The
factory setting for the Drive Past Wire function
function is 31 cm. You can select a distance of
20-50 cm.
Note: With the factory setting the product will cut
11 cm past the wire.
To set the Drive past wire
Settings > Installation > Drive past
1. Select
wire in the app.
2. Move the horizontal bar to set the distance.
Save .
3. Select
3.12.3.4 Starting point
The Starting point function allows you to control
how far the product drives forward from the
charging station before it starts to operate. Use
this function if the charging station is placed in an
area with limited space, for example under a
veranda.
Note: Starting point must not be set to a distance
longer than the distance the guide wire is
installed in a line in front of the charging station.
To examine where to put the guide wire
Refer to
on page 21 .
To set the starting point
Settings > Installation > Starting point
1. Select
in the app.
2. Move the horizontal bar to set the distance.
Save .
3. Select
3.12.4 Accessories
Accessories you can change the
In
settings of the product accessories. To
change the settings, obey the
instructions in the Automower
Connect app.
3.12.4.1 To avoid collisions with the mower
house
When this option is enabled, the wear on the
product and the house is reduced, but it can
result in more uncut grass around the charging
station.
Settings > Installation > Mower house
1. Select
in the app.
30 - Installation
on/off to enable or disable the
2. Select
function.
Save .
3. Select
3.12.5 General (Bluetooth
This function is used to set time and
date, or to reset to default settings. To
change the settings, obey the
instructions in the Automower
Connect app.
3.12.5.1 Time & date
The time and date can be changed manually, or
by using the time and date from the mobile
device.
To set the time & date
Settings > General > Time & Date in
1. Select
the app.
Time & Date from phone or select the
2. Select
pencil to enter the correct time and date.
Save .
3. Select
3.12.5.2 Reset to factory settings
The user settings can be reset to factory settings.
PIN code, Loop signal, Messages and Date
Note:
& Time will not be reset.
To reset to factory settings
Settings > General > Reset in the
1. Select
app.
Reset to factory settings .
2. Select
3.12.6 Security (Bluetooth
The security settings controls the PIN
code, the GeoFence and other security
®
functions. To change the settings,
obey the instructions in the
Automower
PIN-code must be entered to get
access to the
Automower
3.12.6.1 New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if 2 adjacent
installations have a very similar signal.
®
only)
®
®
only)
®
Connect app. The correct
Security menu in the
®
Connect app.
1427 - 002 - 20.12.2019