Sanyo FXC-503LD Operating Instructions Manual page 14

Notes
When using a two-speaker installation, set the FADER control to the center position.
When not using a Power Antenna/External Amplifier, cover the end ot the Blue/Red wire with
electrical tape to prevent it from shorting to the unit or vehicle chassis.
When using a two-speaker installation, the Violet, Gray/Black, Green and White/Black wires,
which are used for a four-speaker installation, are not used. The ends of these wires must be cov-
ered with electrical tape to prevent them from shorting to the unit or vehicle chassis.
\
Fuse 10A
Burnt
When fuse replacement is necessary remove
the blown fuse by using pliers. Then install the
new 10 amp fuse.
LINE OUT/CD CHANGER
CONNECTIONS(FXC-SOSLD
Only)
Since this unit hasa CD changer controller end output terminals, you can use-a CD changer and an amplifier
to upgrade your vehicle stereo system.
CD Changer
Rear Speaker
CD changer DIN Socket
Connect the DIN socket to the CD c~anger using a DIN cable (8 pin) which is supplied with the "FXD-C200
(1 O-disc)", and the'FXD-C100 (6-disc)" CD changer.
RCA Line-out Jacks (For Rear Speakers)
Connect the Red (rearright channel) and White (rear left channel) RCAline-out jacksto each of the input termi-
nals of the external amplifier for the rear speakers.
-13-