Advertisement
Directions for use
Start-up
- Be sure the emergency terminals 5,6 on J4 are short circuited through a wire if
there is no emergency switch.
- If the switching on of the unit has to be performed remotely , insert a switch or two
N.O. dry relay contacts between terminals 3 and 4 on J4 (ON-OFF remote)
- Before switching on the unit, be sure that the input voltage corresponds to the one
shown on the data plate.
- The power supply must be ON for at least 10 seconds before activating the remote
operation through the RS232 serial line (PC typically).
Getting started
- Be sure the unit has been correctly connected to the mains supply and to the lamp.
- Power the unit.
- Select the operation mode (through serial line or synoptic panel). Otherwise the
default parameters (manual mode) will be ON.
- Enter the lamp parameters (according to the lamp type) through the serial mode or
the synoptic panel. Otherwise the default parameters (i.e. the factory setting) will be
ON.
- Strike the lamp according to the preset operation mode.
MAN01554E/1
18
Advertisement
