Operation - Becker BLU-BKR Installation Manual

Fig. 4a
CDR30/31 Radio installs
1. Disconnect Radio Quadlock plug from radio and connect to mating
connector on power harness (to car)
2. Connect power harness male Quadlock to radio (See Fig. 6).
Fig. 6
CDR30 power harness
:

Operation:

One of the most important steps in this process is enabling AUX function within
Becker radio menu. Most Becker radios are pre-programmed to recognize a CD
changer connection and because of that you must perform the following steps and
change setting from CD changer to "AUX" otherwise the adapter will not perform as
intended.
Enabling the AUX function
Radios with TP button: (i.e. CDR-220)
1. Turn radio "ON"
2. Press and hold the "TP" button for about 8 seconds until Becker 1 is
displayed.
3. Turn the Tuning Knob until AUX OFF is displayed.
4. Press either button located directly under the Arrows on the display to
change the present setting from OFF to ON.
Turn radio OFF.
5. Turn Radio back "ON" Press "S" button to enter AUX Mode. This is the
mode to use whenever you want to listen to the Audio device.