Installation - Becker BLU-BKR Installation Manual

Introduction:
Thanks to the BLU-BKR Kit you can keep the radio and car you love while
enjoying Bluetooth features only available on new cars.
With Bluetooth Technology and your Smartphone's built in Advanced Audio
Distribution Profile (A2DP), you can stream music from compatible smartphone or
Tablet directly into all Becker AUX Ready radios. This clean solution leaves no wires
on or around the dash. Simply pair up the Bluetooth device to the adapter hidden
behind the dash set radio to "AUX" mode and enjoy the cleanest playback without
any wires or complicated setup.

Installation:

Although not critical, we recommend disconnecting the car
battery. Keep in mind that most Becker radios are coded and will
not operate without the code. Radio code must be available for
radio to operate upon reconnection.
Remove radio from dashboard to gain access to the connectors. This process
requires special removal tools (not included) (See Fig. 1).
To remove radio, slide tools into slots to detent position. Withdraw the
1.
radio by pulling outwards. See Fig. 2
Fig. 1
Radio removal Tools
With radio removed disconnect and separate the blue, green and yellow
2.
plugs (C1, C-2 and C-3) from Radio connector (See Fig. 3)
Radio chamber C-1, C-2 and C-3 may be empty. These
chambers are reserved for amplifier (C-1) and CD
Changer (C-2 & C-3). CD Changer (if present) must
be disconnected (both blue AND green plugs)
Radio connector
Fig. 2
Fig. 3