Konica Minolta FS-534 Installation Manual page 9

27. Remove the protective tape.
28. Remove the screw shown in the illustration and
remove the label from the finisher.
29. Remove the plate shown in the illustration from
the lower right side of the finisher. (One screw)
30. Reattach the plate removed in step 29 in the ori-
entation shown in the illustration. (One screw
removed in step 29)
Label
A3EPIXC020DB
A3EPIXC021DA
A3EPIXC022DA
E-9
31. Attach the supplied exit tray (lower) to the fin-
isher. (Two supplied screws A)
32. Insert the supplied exit tray (upper) into the fin-
isher.
33. Connect the horizontal transport unit connector
to the connector located at the rear of the right
side of the finisher.
A3EPIXC023DA
A3EPIXC024DA
A3EPIXC025DB