Subscribe to Our Youtube Channel
Related Manuals for Konica Minolta FS-501
Summary of Contents for Konica Minolta FS-501
- Page 1 INSTALLATION MANUAL FS-501 Finisher for Product Code 4036 NOTES • Before installing, be sure to unplug the power cord of the machine. • Keep all packing materials out of the reach of children. 4684-7761-03 Printed in Japan...
- Page 2 FS-501 ■ Outline of Installation Procedures for 4036 System When installing the machine and associated options as a system, follow the order shown on the left. PC-101 PC-201 PC-401 DK-501 NOTE For the detailed installation procedures for each option, follow the instructions given in the corresponding Installation Manual and perform the procedures correctly.
-
Page 3: Unpacking The Finisher
<Machine + Paper Feed Cabinet PC-401> 11 Screws A ....................3 12 Screws B ....................2 13 Installation manual (this manual) ............1 14 Spacer ....................1 Rail Guide A is not used when the FS-501 is mounted on the machine (product code 4036). 4684U059AA <Machine + Desk> 4698U044AA... - Page 4 FS-501 2. Remove all tape and packing brackets. NOTES • Make sure that the installation site is flat and level. Tape • After the Finisher has been set up, avoid moving it unless it is absolutely neces- sary. When the Finisher needs to be moved, perform the steps by referring to “Removing the Rail”...
-
Page 5: Installing The Accessories
FS-501 ■ Installing the Accessories 5. Insert the rail into the Rail Guide B. 1. Peel off the seal covering the area where the stabilizing pin and magnet plate will be 6. Protrude the leading edge of the rail out attached. - Page 6 FS-501 ■ Unpacking the Horizontal Transport Unit ■ Adjusting the Height and Tilt of the Finisher Remove all packing materials and tape. 1. If the finisher gradually tilts toward the machine, check the following: • Are the stabilizing pin and the hole in the fin- isher at the same height? •...
- Page 7 FS-501 ■ Connecting the Hookup Cord 4. Without turning the adjusting bolt (lower bolt) 1. Remove the connector covers from the Securing bolt on the caster, loosen the securing bolt (upper horizontal transport unit and the machine. bolt), and then turn the adjusting bolt (lower...
-
Page 8: Removing The Rail
FS-501 ■ Installing the Tray and Protective Guide ■ Affixing the Labels Affixing the enclosed operation labels. Install the enclosed tray and protective guide at the positions shown in the illustrations. Label for Machine Label for RADF 4643U024AA C4683U018BA 4698U109AA...
Need help?
Do you have a question about the FS-501 and is the answer not in the manual?
Questions and answers