Console Complexing (Physical); Module Installation; Peripheral Installation And Cabling - Honeywell TotalPlant LCN System Installation

B
OPTIONS INSTALLATION
US/ERGONOMIC FURNITURE
Appendix B
This section provides brief installation procedures for adding an option or feature to an existing
Universal Station X node in the new ergonomic furniture. These procedures, together with the
information contained in the various service manuals, provide the necessary information to modify
or expand your system.
B.1 CONSOLE COMPLEXING (PHYSICAL)
Refer to Section 3 for instructions about complexing Operator Interface Stations (OIS's)
into physical consoles.
B.2 MODULE INSTALLATION
Refer to the Section 2 in Universal Station (Ergonomic) Service for detailed instructions for
adding an upper monitor and adding an additional card file.
B.3 PERIPHERAL INSTALLATION AND CABLING
The standard built-in peripherals, cartridge disk drives, and trend-pen recorders, are
installed and cabled into the Universal Station at the factory. Removal and replacement
procedures are provided in the applicable service manual and installation drawings.
Upgrade kits contain an individual upgrade kit installation instruction that provide step-by-
step instructions for adding or expanding options.
The matrix printer is packaged separately for shipping.
After unpacking, position the printer on the table top. Route the power cord and data
cables down the back of the console and up through the cable cutouts. Connect the power
cord into any unused receptacle on the power entry box. The data cable connections, as
applicable to the Universal Station, are shown in Figures B-1, Figure B-2, and Figure B-3.
LCN System Installation B-1 9/96