Installation And Connection; Electrical Connection - Beko HIML 95225 SXE User Manual

3 Installation
Total gas con-sump-
tion (kW)
0-2
2-3
3-4
4-6
6-8
8-10
10-11.5
11.5-13
13-15.5
15.5-17
17-19
19-24
If the doors or windows that open directly to the
outer environment do not have openings corre-
sponding to the ventilation opening specified
according to the total gas power of the product,
there must definitely be a fixed ventilation open-
ing in the doom. The fixed venti-lation opening
should also be in compliance with the values in
the gas power-ventilation opening table. There
should be a minimum clearance of 10 mm on the
bottom edge of the door-that opens to the inner
environment- in the room where the product is
instal-led. You must make sure that items such as
carpets, floorings, etc. do not cover this clearnace
when the door is closed.
The cooker may be located in a kitchen, kitchen/
dinner or a bed-sitting room, but in a room con-
taining a bath or shower. The cooker must not be
installed in a bed-sitting room of less than 20m³.
Do not install this appliance in a room below
ground level unless it open to ground level on at
least one side.
14 / EN
min. Ventilation
opening (cm²)
100
120
175
300
400
500
600
700
800
900
1000
1250

3.2.1 Installation and connection

The product must be installed in accordance with
all local gas and electrical regulations.

3.3 Electrical connection

Connect the product to a grounded outlet/line
protec-ted by a fuse of suitable capacity as stat-
ed in the "Technical specifications" table. Have the
grounding installation made by a qualified elec-
trician while using the product with or without a
transformer.
The Manufacturer shall not be liable for any dam-
ages that will arise due to using the product with-
out a grounding installation in accordance with the
local regulations.
WARNING: The product must be
connected to the mains supply only
by an authorised and qualified per-
A
son. The product's warranty period
starts only after correct installation.
Manufacturer shall not be held re-
sponsible for damages arising from
procedures carried out by unauthor-
ised persons.
WARNING:
ble must not be clamped, bent or
trapped or come into contact with
A
hot parts of the product.
A damaged power cable must be
replaced by a qualified electrician.
Otherwise, there is risk of electric
shock, short circuit or fire!
• Connection must comply with national regula-
tions.
• The mains supply data must correspond to the
data specified on the type label of the product.
Type label is at the rear housing of the product.
• Power cable of your product must comply with
the values in "Technical specifications" table.
Built-In Hob / User Manual
The power ca-