Page 2
This is a Nordson Corporation publication which is protected by copyright. Original copyright date 1997. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Nordson Corporation. The information contained in this publication is subject to change without notice.
It is the responsibility of the company operating the equipment to see that its personnel meet these requirements. 45--PG--MA--01 (formerly PG...) P/N 317163B E 1998 Nordson Corporation All rights reserved Issued 10/98...
In case of burns: Immediately cool affected skin areas using cold, clean water. Do not forcefully remove hot melt material from the skin. Immediately seek medical attention. P/N 317163B 45--PG--MA--01 (formerly PG...) E 1998 Nordson Corporation All rights reserved Issued 10/98...
Any other use is considered as not intended and is carried out at the operator’s own risk. Nordson will not be responsible for personal or equipment damage resulting from unintended use. Intended use also includes the observance of Nordson safety instructions.
Pt 100 Temperature sensor L Equipment variant (here: without control lead) 10 Nominal width of hose core in mm 15 Nominal length in dm PG Series P/N 317163B 45--PG--MA--01 (formerly PG...) E 1998 Nordson Corporation All rights reserved Issued 10/98...
Units with Fixed Connection applicator input power line. 2. Move the applicator circuit breaker to the OFF position. 4110132 Fig. 2 Disconnecting and Locking Out Main Power 45--PG--MA--01 (formerly PG...) P/N 317163B E 1998 Nordson Corporation All rights reserved Issued 10/98...
2. Heat the unit and hose to approx. 80 _C (176 _F). 3. Screw the hose onto the unit. MXHH001S050A0295 Fig. 4 NOTE: Close unused hose connection fittings with Nordson screw caps. Disconnecting WARNING: System and hot melt material pressurized. Relieve pressure before disconnecting heated hoses. Failure to observe can result in serious burns.
1. Check all hoses and fittings for leakiness. Replace leaking hoses. 2. Condition Check Tighten screw connections if necessary. Use a second open--jawed wrench. 2. Check electrical plug connections for tightness. P/N 317163B 45--PG--MA--01 (formerly PG...) E 1998 Nordson Corporation All rights reserved Issued 10/98...
Residues of the cleaning agent can be flushed out of the unit by the new hot melt material before production begins. NOTE: Ensure proper disposal of the cleaning agent according to local regulations. 45--PG--MA--01 (formerly PG...) P/N 317163B E 1998 Nordson Corporation All rights reserved Issued 10/98...