Table of Contents
Advertisement
4. Pivot the expansion unit closed, and press it firmly into place until the
5. If you have other devices to install or remove, do so now; otherwise, go to
Installing the blade appliance in a BladeCenter unit
Use these instructions to install the blade appliance in a BladeCenter unit.
The following illustration shows how to install a blade appliance into a
BladeCenter unit. See the documentation for your BladeCenter unit for additional
information. To install a blade appliance in a BladeCenter unit, complete the
following steps.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
16
IBM WebSphere DataPower Integration Blade XI50B Type 4195: Installation and User's Guide
expansion-unit releases click. The connector on the expansion unit
automatically aligns with and connects to the blade expansion connector on the
system board.
"Installing the blade appliance" on page 15.
1. Before you begin, read "Safety statements" on page vii and "Installation
guidelines" on page 13.
2. Select the blade bays for the blade appliance; two blade bays are required.
Notes:
a. For BladeCenter units that have multiple power domains, make sure that
the blade appliance is installed in a power domain that has power. For
example, when any blade appliance or device is in blade bay 7 through 14
of some BladeCenter units, power modules must be installed in all four
power-module bays. For additional information, see the Installation and
User's Guide that comes with the BladeCenter unit.
b. If you are reinstalling a blade appliance that you removed, you must
install it in the same blade bays from which you removed it. Some blade
appliance configuration information and update options are established
Advertisement
Table of Contents
