Page 1
Automatic.Hose.Reel. Installation, Use, and Maintenance Guide Caution: This.hose.reel.is.not.intended.to Caution: Except.as.indicated.in.these be.used.as.a.potable.water.source instruction.do.not.open.the.outer.housing Unpacking Hardware.Pack Please.check.the.contents.of.your.package Contents A, Instruction.Manual B, Hardware.Pack C, Hose.Reel D, Wall.Bracket E, Mount tube Couplings Your hose reel was made with one of B.1 X 4 The following hose-end configurations Poly quick-connect with nozzle Preparing.your.tools...
Page 2
READING: please check which mold you have, and then get the installation dimension from the table below. Model number Hardware pack BXGT10147E 57mm(2-1/4”) 165mm(6-1/2”) , The mounting bracket has 4 holes which will be used to secure it to the wall or timber post.
Operating Instructions Caution: Always hold the hose until it Caution: The yellow tape marks the end completely. retract into the hose reel of the hose length. Extending the hose 1, Pull the hose out to the desired length. The hose will automatically lock in position Anywhere lock: Pull out the hose to the desired length and then stop pulling so the reel can lock in the desired position.
Page 4
Caution: Always make sure the hose reel is locked before removing the stop ball, and make sure the stop-ball is securely fastened before unlocking the reel. Adjusting the stop-ball The location of the stop ball can be adjusted to allow more or less hose exposed when fully rewound. 1, Pull out the hose to the desired length, ensuring the hose reel is locked ( will not rewind).