Table of Contents
Advertisement
Mounting the Arjent
Preparing the Lightbar
To prepare the lightbar for mounting on the vehicle:
1. Turn the lightbar assembly over on soft rags or cardboard so that the bottom of the lightbar faces up.
2. See Figure 1. Use the 5/16"-18 x 5/8" ToRx head bolts, 5/16" flat washers, and 5/16" lockwashers to
attach a mounting foot on the mounting bracket:
a)
Position the ToRx head bolts at the bottom of the slots as shown in Figure 1.
b) Tighten the bolts only enough to hold the mounting foot in place.
3. Repeat step 2 with the other mounting bracket.
MOUNTING PAD (2)
MOUNTING FOOT (2)
MOUNTING BRACKET
2
Lightbar on a Vehicle Roof
®
Table 1 Kit contents (continued from previous page)
Qty.
Description
2
Bracket, Mounting
2
Foot, Mounting, Drvr‑Front/Pass‑Rear
2
Foot, Mounting, Drvr‑Rear/Pass‑Front
4
Bolt, Rd. Hd. Carriage, 3/8‑16 x 7/8
2
Screw, Set, #8‑32
2
Stop, Mounting Bolt
8
Screw, #10, Thd. Frm. Hex Hd.
4
Plug, Cap, Vinyl
2
Label, Extrusion, Arjent
Figure 1 Mounting feet attached to mounting bracket
Model XHK-SD Mounting Kit
Part No.
8583189
8583082
8583083
7004A024‑14
7008A012‑05
8583126
7011A135‑10
231214
1612192
5/16" SPLIT
LOCKWASHERS (4)
5/16" FLAT
WASHERS (4)
BOLT, 5/16-18 x 5/8"
TORX PAN HEAD (4)
BOTTOM OF SLOT
290A6696
Advertisement
Table of Contents
