Test And Diagnostics Options - Fein Dustex 25 L Repair Instructions

Saugen

Test and diagnostics options

7 Test and diagnostics options
Fault
Suction turbine does not run
Suction turbine switches off
Suction turbine does not restart
after emptying the container.
Suction power drops
Dust escapes when vacuuming
Automatic shut-down (wet
extraction) does not respond
C-SC_CSSM
Remedy
Switch on the appliance.
Check the mains cable, plug, fuse, socket and fill level sensors
Operating mode selector switch is set to 'Automatic Start/Stop'.
Set the operating mode selector switch to the 'Vacuum' symbol and
switch on the power tool that is connected to the socket.
Check/replace the appliance switch. Check the socket.
Check/replace the control board.
Container is full in wet operation. Empty the container.
Empty the container.
Switch off the suction and wait for five seconds. Switch back on
after five seconds.
Clean the fill level sensors and the space between the fill level
sensors with a brush.
Remove the obstruction from the suction nozzle, pipe, hose or flat-
fold filter.
Change the disposal bag/dust bag.
Install the filter cover correctly.
Place the extractor top correctly and close locks.
Check the suction system for leaks.
Change the fleece filter bag.
Change the flat filter.
Check the vacuum with the pressure gauge on the tool collar.
Vacuum minimum 200 mbar.
Check that the flat-fold filter is inserted correctly.
Change the flat-fold filter.
Clean the fill level sensors and the space between the fill level
sensors with a brush.
Automatic shutdown does not function with electrically non-
conductive liquids or foam formation. Check the fill level regularly.
Version 1.0
All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation.
10.12.2019 Page 11 of 45