To Lay And Connect Additional Wiring Harnesses; To Lay Additional Wiring Harnesses - BMW SA640 Installation Instruction

3.5 To lay and connect additional wiring harnesses

Fold out folded page 65.
3.5. 1

To lay additional wiring harnesses

The installation of the speaker wiring harness IV and the switch module V is not necessary on cars with a
BMW Professional DSP hi-fi system.The installation of the power supply wiring harness II is not necessary on cars
with a 12-pin white telephone SA plug X400. On cars with an existing speaker wiring harness on the socket casing
of plug connector X322, there is no need to install the speaker wiring harness IV. On cars with blind stoppers in
the socket casing of plug connector X322, these must be removed.
Connection cable I:
Lay this cable from SA plug X400 and the base interface in the boot on the left-hand side, along the vehicle wiring
harness to the armrest in the centre console.
Power supply wiring harness II (cars without telephone SA plug X400 only):
Lay this from the white plug connector X322 in the boot on the left-hand side, along the vehicle wiring harness to
the fuse holder IV X10018 and to the plug connector X325 in the boot and to the ground post X13075 at the
C pillar on the right-hand side.
Microphone wiring harness III:
Secure the microphone wiring harness III so that no deterioration in function occurs on cars with an ITS
head airbag.
Lay this wiring harness from the base interface on the left-hand side wheel arch along the vehicle wiring harness
to the left-hand C pillar and under the roof liner to the installation site of the microphone near the front interior light.
Speaker wiring harness IV (cars without a BMW Professional DSP hi-fi system only):
Before installing the speaker wiring harness IV, check the 12-pin socket casing X322 in the boot on the
left-hand side to find whether the following slots are occupied:
If these slots (8, 9 and 10) are occupied, the speaker wiring harness is not to be installed. If the socket contact on
slot No. 8 (mute cable) does not exist, press in branch IV/3 and lay branch IV/6 to the installation site for the radio.
If there is a socket contact on the 12-pole socket casing, insulate branches IV/3 and IV/6 and tie them back on
the wiring harness.
LHD cars without existing speaker wiring harness:
Lay the wiring harness from plug connector X322 along the vehicle wiring harness to the A pillar on the left-hand side.
RHD cars without existing speaker wiring harness:
Lay the wiring harness from plug connector X322 along the vehicle wiring harness to the A pillar on the right-hand
side.
Switch module V (cars without a BMW Professional DSP hi-fi system only):
(LHD cars):
Install the switch module in the A pillar on the left-hand side.
(RHD cars):
Install the switch module in the A pillar on the right-hand side.
Switch module VI adapter cable (cars with on-board monitor radio only):
(LHD cars):
Lay the adapter cable from the A pillar on the left-hand side to the installation site for the on-board monitor radio
on left-hand side of the boot.
(RHD cars):
Lay the adapter cable from the A pillar on the right-hand side to the installation site for the on-board monitor radio
on the left-hand side of the boot.
3-44/EN
Cable colour
white/brown
black/white
black/brown
Slot
8
9
10