SELFSAT SNIPE DRIVE User Manual page 8

3. Operating Instruction
E. Factory reset
a. Press and hold SET button for more than 5 seconds till TRACKING & LOCK
LEDs blink
b. Factory reset takes less than 3 seconds and reboot the system
c. When factory reset is completed, the unit back to default (in-motion) mode
d. Default satellite is selected then the unit automatically starts searching
F. Changing the satellite
a. Once antenna and controller are connected, you can select & change the
satellite as you require.
b. Select the desired satellite using the "Arrow" buttons, then press the "SET"
button to accept the setting.
c. If you select the wrong satellite, you can re-search target satellite using the
"Arrow" buttons, then press the "SET" button to accept the new setting.
For example :
"Arrow" buttons
"SET" button
7