Changing The Device Keys - Philips SBCRU641/87 User Manual

XP SBC RU 641/87
4
ADVANCED TIPS AND TRICKS
Carefully read the complete procedure before starting!

Changing the device keys

With the mode selector it is possible to select 4 categories of
devices you want to operate. Each category (TV, VCR, SAT and
DVD) is meant to operate a specific group of equipment:
TV
tv
Once you have programmed the functions of a device in one
of the categories, it is not possible to program another device
in the same category. There is, however, a solution in case
you want to program two devices in the same category
(2 TV's, VCR's, etc.). The following example explains how.
EXAMPLE:
The SAT mode on this remote control is factory preset to
control many Philips satellite receivers. You can change the
SAT mode (or any mode) to operate another type of device.
The following example shows you how to use the SAT mode to
operate a second TV:
VCR
SAT
TV DVD
6
1
9 9 2
VCR SAT
DVD
TV
1
Don't forget to set up the SBC RU641 to operate this second
TV. See the section Set-up for use.
6
15-10-2001 12:49
Instructions for use
7
Press key 4 and count the number of flashes for the forth
digit.
8
Note the code.
A d v i c e
VCR
vcr
1
Press the mode selector key to select SAT and make sure
the second TV is switched on.
2
Press and hold keys 1 and 6 simultaneously -for about 3
seconds- until the green LED lights up.
3
On the keypad, press keys 9, 9 and 2.
4
Press the mode selector key to select TV mode.
5
Press key 1.
– The LED flashes twice to indicate successful set up.
That's it!
Pagina 6
SAT DVD
sat dvd
cable