Difficult Start Up; Stopping The Engine - PIAGGIO Beverly 125 Maintenance Manual

Difficult start up (02_08)

Should there be any problem, proceed as follows:
1. If the engine is flooded. Follow the same sequence of operations described above.
Fully accelerate and press the starter button «G » for 5 seconds and then stop for 5
seconds keeping the throttle fully twisted, as fuel is delivered to the cylinder each time
the throttle valve opens and closes.
If the engine does not start after a few attempts, let the engine rest for a few minutes
and then repeat the above operations. In any case do not operate the starter long in
the attempt to start the engine.
02_08
As a last alternative, remove the spark plug and operate the engine start-up to so as
to expel fuel excess; then refit the spark plug and repeat the process from point 1.
2. If the tank runs out of fuel. After refuelling the scooter, start the engine by pressing
the starter button «G» with the throttle completely untwisted to provide maximum de-
pression to the fuel pump.
3. If the engine overheats. Follow the same sequence of operations keeping the
throttle grip slightly twisted.
If the scooter fails to start even after taking the steps described above, take it to an
Authorised PIAGGIO Dealer or Service Centre.

Stopping the engine (02_09)

Fully untwist the throttle grip, then rotate the key in the switch «A » to «KEY
OFF» (extractable key).
CAUTION
DUE TO THE HIGH TEMPERATURES THE CATALYTIC CONVERTER CAN
REACH, ALWAYS TAKE CARE, WHEN PARKING THE SCOOTER, THAT THE
02_09
31