Start-up button (01_31, 01_32)
Make sure the engine stop switch«A» is in the Run «1» position that the side stand is
in a raised position.
To start the engine, pull either one of the two brake levers and press the starter button
«B».
The vehicle is equipped with assisted starter procedure management. The starter
motor remains active for a few seconds until the engine starts even if switch «B» is
released.
01_31
Keep one of the two brakes operated (front or rear) so as to not interrupt the starter
procedure.
The throttle grip must remain in the minimum position, because any other position
inhibits the vehicle starter.
The starter motor will remain active for a maximum of 5 consecutive seconds.
01_32
Engine stop button (01_33)
The engine can be started when the emergency stop switch «A» is in position «1»
RUN; if the emergency stop switch «A» is in position «0» OFF the engine cannot be
started or it stops if it was running.
01_33
28