Swc Input Operation - Dual DMCPA11BT Installation & Owner's Manual

DMCPA11BT
The built-in SWC Interface is compatible with PAC steering wheel control modules.
The PAC SWI-RC is recommended. A third-party adapter must be used in order for the
DMCPA11BT to be compatible with any steering wheel controls. The following controls are
available for most vehicles.
1. Reset
2. Mode
3. Seek/Track Up (+)
Note: Not all OE steering wheel functions may be supported by the DMCPA11BT.
1. Set "Radio Select Switch". Set the SWI-RC to position 7 - "Pioneer/Other/Sony".
2. To program, use the Pioneer/Sony/Other radio function mapping order for Dual units.
3. When programming the SWI-RC, if a function is not supported (or not desired), then the
function MUST be skipped as per the PAC SWI-RC instructions.
4. The SWC function MUST be programmed in the correct order per the PAC SWI-RC radio
function mapping order instructions.
Function
Order
1
2
3 Seek + / Track +
4
5
6
7
8
9
10
22
DMCPA11BT.indd 22
OPERATION

SWC Input Operation

4. Seek/Track Down (-)
5. Mute
6. Volume Up (+)
PAC SWI-RC Installation Hints
Function
Center Pin (Ring) Voltage
Mapping
Reset
Mode
Seek - / Track -
Mute
Volume +
Volume -
Band
BT Talk
BT End
7. Volume Down (-)
8. Band
9. BT Talk
SWI-RC (3.3VDC Reference)
(Function Select)
H 3.3v
H 3.3v
H 3.3v
H 3.3v
H 3.3v
H 3.3v
L 0.0V
L 0.0V
10. BT End
Tip Pin Voltage
0.6
1.81
1.01
2.07
2.32
2.73
0.60
1.01
2019/9/23 15:46:27