Swc Input Operation - Dual DCPA1013 Installation & Owner's Manual

The built-in SWC Interface is compatible with PAC steering wheel control modules.
The PAC SWI-RC is recommended. A third-party adapter must be used in order for the
DCPA1013 to be compatible with any steering wheel controls. The following controls
are available for most vehicles.
1. Reset
2. Mode
3. Seek/Track Up (+)
Note: Not all OE steering wheel functions may be supported by the DCPA1013.
PAC SWI-RC Installation Hints
1. Set "Radio Select Switch". Set the SWI-RC to position 7 - "Pioneer/Other/Sony".
2. To program, use the Pioneer/Sony/Other radio function mapping order for DUAL units.
3. When programming the SWI-RC, if a function is not supported (or not desired), then the
function MUST be skipped as per the PAC SWI-RC instructions.
4. The SWC function MUST be programmed in the correct order per the PAC SWI-RC radio
function mapping order instructions.
Function
Order
1
2
3
4
5
6
7
8
9
10

SWC Input Operation

4. Seek/Track Down (-) 7. Volume Down (-)
5. Mute
6. Volume Up (+)
Function
Mapping
Reset
Mode
Seek + / Track +
Seek - / Track -
Mute
Volume +
Volume -
Band
BT Talk
BT End
8. Band
9. BT Talk
SWI-RC (3.3VDC Reference)
Center Pin (Ring)
Voltage
(Function Select)
H 3.3v
H 3.3v
H 3.3v
H 3.3v
H 3.3v
H 3.3v
L 0.0V
L 0.0V
DCPA1013
10. BT End
Tip Pin Voltage
0.6
1.81
1.01
2.07
2.32
2.73
0.60
1.01
24