Control Panel - Panther S-TYPE DOLLY User Manual

CONTROL PANEL

CONTROL LEDs
Control LEDs:
Red, yellow and green LED will light up for 2 sec. if dolly
is switched on.
Power:
Brake open:
Battery
empty/error:
Error determination of Panther Electronic Box:
b
: (on) battery empty
E
. (blinking )fault at end switch
L
. (blinking) current exceeding normal value
yellow LED will light up when
the dolly is turned on
is
green LED
minimum limit is
active. It will light
up when the brake
is open. It is also blinking if a limit is activ and the brake
is open. If the dolly is not in operation for longer than 120
seconds, the brake will close automatically and the LED will
go out/respectively blinking in another frequency.
red LED is blinking if a maximum limit is active. It will light up when
batteries are empty or in case of an error. The error can be
determined by removing the electronics cover and looking at
the display on the left side of the electronics housing:
blinking if a
d
. (blinking )fault at rotary encoder
H
. (blinking) fault at handset
26