Pid Tuning - Monoprice MP Delta Pro User Manual

5. Touch Push Rod Length, erase the old value, then enter the new value.

PID Tuning

If you find that the nozzle fails to maintain a stable temperature or fails to reach the target
temperature, you can run the auto-PID tuning procedure to attempt to correct the issue. If
nozzle temperature issues persist after running the auto-PID tune, you may need to replace
the thermistor or heater. Perform the following steps to run an auto-PID tune.
1. The tuning process varies slightly depending on the nozzle hotend type and the
target temperature of the material you are using. For the PTFE-lined nozzle, turn the
part cooling fans (side fans) to 100% power before proceeding to tune the PID.
Leave the fans off for the all-metal nozzle and materials with target temperatures
higher than 260°C. To control the fans, touch
(default) or 0%, then touch
>
.
13
. Set the fans to 100%