Parameter Setting - Ista Ultego III perfect Manual

ultego® III perfect

Parameter setting

Setting the date / time
Units with a power supply unit or new battery connected in situ may start directly in the setting menu for the date and time..
Press LCD button 1 repeatedly until the required value is shown. Then press LCD button 2. Change the value for the date or
time as described under Performing parameter setting.
Calling the parameter setting function
Press the service button for about 3 s. The LCD shows the display
In this state, you can parameterize the tariffs and fast pulses using the PappaWin software.
LCD button 1 advances the display.
Press LCD button 1 repeatedly until "PArA" is shown. Then press LCD button 2.
The following parameter settings are possible:
G.83.0101
ultego® III perfect
ista International GmbH – Grugaplatz 2 – D-45131 Essen
Cover tabs
NOTE:
The housing cover has to be removed temporarily in order to operate the service button.
Enter the date
Enter the time
Return to normal mode (manual)
CAUTION:
For fast pulses in battery operation, a D cell is required.
Call test mode
Call parameter setting mode
Return to normal mode (manual)
6.1 - 230608
LCD button 1
LCD button 2
Cover tabs
LCD display
Adhesive label
Service button
.