Gaggenau RB472704 Instruction Manual page 15

Notes
Discard the first 30-40 ice cubes for hygiene reasons.
▯
Ice cube production stops automatically when the ice
▯
cube container is full.
Information about switching ice cube production on and
off
~ "Switching ice cube production on or off"
on page 18
Ice pack
In the event of a power failure or a fault:
The ice pack delays the warming of stored frozen
▯
food.
Note: The longest storage time is obtained by placing the
ice pack on the food in the top compartment.
You can take out the ice pack to temporarily keep food
cool, e.g. in a cool bag.
Particle filter
The particle filter supplied will only filter particles out of
drinking water, not bacteria or microbes.
The particle filter can remain in the appliance
permanently: it does not need to be changed.
Note: You can also use the appliance with a water filter. If
you have replaced the particle filter with a water filter, you
must switch the water filter counter on.
~ "Switching the water filter counter on and off"
on page 19
The water filter must be changed regularly. To do so, note
the information on the water filter.
A new particle filter or a water filter can be obtained from
customer service or a specialist dealer.
Cleaning particle filter
The particle filter can remain in the appliance
permanently: it does not need to be changed. We
recommend cleaning it once a year.
This is how to clean the particle filter:
1.
Turn the cap of the particle filter counter-clockwise.
2.
Pull out the particle filter.
3.
Remove the inner filter at the rear of the particle filter.
4.
Clean the filter under running water.
5.
Replace the filter at the rear of the particle filter.
6.
Slide the particle filter to the stop in the filter opening.
Note: The holder on the cap must be horizontal here.
7.
Turn the particle filter clockwise to the stop.
8.
When using a water filter: Reset water filter counter.
~ "Reset water filter counter" on page 18
Getting to know your appliance
Note: When a particle filter is used, the water filter
counter is not required and therefore remains
switched off.
Changing the particle filter or replacing with a water
filter
The particle filter can remain in the appliance
permanently: it does not need to be changed. You can,
however, change the particle filter, if necessary, or
replace it with a water filter.
Note: After installing a particle or a water filter, discard
all ice cubes produced over the first 24 hours.
1.
Turn the cap of the particle filter counter-clockwise.
2.
Pull out the particle filter.
3.
Remove the protective cap from the new filter.
4.
Take off the cap of the old particle filter and put it on
the new particle or water filter.
5.
Slide the new water or particle filter to the stop in the
filter opening.Slide the new particle or water filter to
the stop in the filter opening.
Note: The cap must be horizontal here.
6.
Turn the particle or water filter clockwise to the
marking.
Note: If the particle or water filter is not turned far
enough, damage will be caused by water leaking out.
7.
When using a water filter: Switch the water filter
counter on.
~ "Reset water filter counter" on page 18
Note: When a particle filter is used, the water filter
counter is not required and therefore remains
switched off.
8.
Discard the ice cubes produced over the first
24 hours.
9.
Drain the water out of the old particle filter.
Note: You can dispose of the old particle filter with
your household garbage.
en-us
15