Envirovent FILTERLESS EXTRACT FAN SELV Series Installation Manual For Engineer / Installer page 12

Cleaning
ISOLATE THE UNIT FROM THE MAINS SUPPLY BEFORE CLEANING
1. Remove the front cover.
2. Push the impeller clips towards the centre, then pull the impeller out.
3. Clean the front cover and impeller in warm soapy water and allow to dry.
Use a damp cloth to clean any other parts of the unit.
(Do not use solvents and do not clean any parts in a dishwasher appliance).
4. Clip the impeller back into position, ensuring the clips are engaged. Replace
the front cover and tighten both screws.
THE UNIT WILL NOT OPERATE UNTIL THE FRONT COVER IS FITTED
1
3
12
Filterless Extract Fan
2
4
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
01423 859 395