Table of Contents
Advertisement
Installation
ISOLATE THE MAINS SUPPLY BEFORE BEGINNING THE INSTALLATION
1. Loosen the two screws on the bottom of the unit, leave the screws
in place and remove the front cover.
2. Pull the central cartridge out from inside the rear carcass.
3. Disconnect the green connector end of the power cable from the
unit then set the central cartridge to one side.
4. Connect the power cable and local isolator to the Mains as in the
wiring diagrams shown on page 5. Then tighten the cable gland on
the rear carcass.
1
3
AFTER INSTALLATION THE END USER SHOULD
KEEP THIS GUIDE FOR FUTURE REFERENCE
2
4
DO NOT
THROW AWAY
7
- Quick Links:
- Wiring Diagrams
- Installation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FILTERLESS EXTRACT FAN SELV Series and is the answer not in the manual?
Questions and answers