Envirovent FILTERLESS EXTRACT FAN SELV Series Installation Manual For Engineer / Installer page 10

12. Now apply the adhesive foam pad over the switches.
Not using this will void the warranty and IP rating.
13. Ensure the impeller is fitted correctly, the two clips should both
be engaged.
14. Replace the front cover ensuring the pullcord sits into the slot.
Then tighten the two screws.
The unit will not operate without the front cover in place.
15. The mains supply can now be reactivated.
12
14
10
Filterless Extract Fan
Foam Pad
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
13
15
OFF ON
01423 859 395