Optional Accessories - DeWalt D28710 Original Instructions Manual

EN GLIS H
WARNING: To reduce the risk of
serious personal injury, AlWAyS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the
operating handle (c), with the other hand guiding the
workpiece.
Performing a Cut (Figure 1)
1. Place the material to be cut against the fence (i)
and secure using the material clamp (j).
2. Turn the tool on and pull down the operating
handle (c) to cut the workpiece. Allow the motor
to reach full speed before cutting.
3. Allow the disc to cut freely. Do not force.
4. After completing the cut, switch off the tool and
return the arm to its upper rest position.
Switching On and Off (Figure 1)
The on/off switch (a) is mounted in the operating
handle (c).
To run the tool, press the on/off switch (a).
Keep the on/off switch depressed while performing
the operation.
To stop the tool, release the switch.
The tool can be locked on for continuous use
by depressing the on/off switch (a) and then by
depressing the lock-on button (d). Hold the lock-on
button (d) as the on/off switch (a) is gently released.
To turn the tool off from the locked on position,
squeeze the on/off switch (a) and the lock-on button
(d) is released.
Do not unplug the tool with the switch locked on.
Make sure the tool is not locked on when plugging
in.
WARNING: Do not switch the tool on
or off when under load.
WARNING: Do not cut magnesium.
Transporting (Figure 1)
The tool is equipped with a lock-down chain (u)
which locks the tool in closed-down position for
carrying.
1. Lower the guard (p) onto the cutting table (k)
and secure the tool in this position by hooking
the chain (u) over the lock-down hook (r).
10
2. Transport the tool using the carrying handle (e).
To release the tool, depress the operating handle (c)
slightly and release the chain.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product,
use of such accessories with this tool
could be hazardous. To reduce the risk
of injury, only D
accessories should be used with this
product.
WALT, have
e
WALT recommended
e