Table of Contents
Advertisement
English
Cleaning the D
WALT Corded Power Supply
e
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
Cleaning the Corded Power Supply Receptacle (Fig. S)
WARNING: Blow debris out of the corded power supply receptacle
To minimize the risk of eye injury, always wear approved eye protection and respiratory
protection when performing this.
Dust Duct Cleaning
Depending on your cutting environment, saw dust can clog the dust duct and may prevent dust
from flowing away from the cutting area properly. With the battery pack or corded power supply
removed and the saw head raised fully, low pressure air or a large diameter dowel rod can be
used to clear the dust out of the dust duct.
CUTLINE™ LED Worklight Cleaning
For the best worklight performance, perform the following maintenance regularly with the
battery or corded power supply removed.
•
Carefully clean sawdust and debris from worklight lens with a cotton swab.
•
DO NOT use solvents of any kind, they may damage the lens.
•
Dust build-up can block the worklight and prevent it from accurately indicating the line
of cut.
•
Follow miter saw's instruction manual to remove and install blade.
•
With blade removed from saw, clean pitch and build-up from blade. Pitch and debris can
interfere with the worklight and prevent it from accurately indicating the line of cut.
Accessories
WARNING: Since accessories, other than those offered by D
with this product, use of such accessories with this tool could be hazardous. To reduce the
risk of injury, only D
WALT recommended accessories should be used with this product.
e
Recommended accessories for use with your tool are available at extra cost from your local dealer
or authorized service center.
16
Optional Accessories
The following accessories, designed for your saw, may be helpful. In some cases, other locally
obtained work supports, length stops, clamps, etc., may be more appropriate. Use care in
selecting and using accessories.
Clamp: DW7082
Used for firmly clamping workpiece to the saw fence for precision cutting.
58
with clean, dry air.
Dust Bag: DW7053
Equipped with a zipper for easy emptying, the dust bag will capture the majority of the
sawdust produced.
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
sAW BlADEs: ALWAYS USE 12" (305 mm) SAW BLADES WITH EITHER 1" (25.4 mm) OR 5/8"
(15.88 mm) ARBOR HOLES. SPEED RATING MUST BE AT LEAST 4800 RPM. Never use a smaller
diameter blade. It will not be guarded properly. Use crosscut blades only! Do not use blades
designed for ripping, combination blades or blades with hook angles in excess of 7°.
WALT, have not been tested
e
BLADE DESCRIPTIONS
APPLICATION
Construction saw Blades (maximum thin kerf with anti-stick rim)
General Purpose
Fine Crosscuts
Woodworking saw Blades (provide smooth, clean cuts)
Fine crosscuts
Non-ferrous metals
nOTE: For cutting non-ferrous metals, use only saw blades with TCG (Triple Chip
Grind) teeth designed for this purpose.
DIAMETER
TEETH
12" (305 mm)
40
12" (305 mm)
60
12" (305 mm)
80
12" (305 mm)
96
Advertisement
Table of Contents
