Cleaning; Cleaning The Interior And The Exterior Of The Unit; Cleaning The Ice Bucket; Cleaning The Dispenser - Kenwood KSBSDIX16 Installation Instructions Manual

cleaning

cleaning the interior and the exterior of the unit

• Remove all the shelves and drawers.
• Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with warm
water using a sponge or cloth. Wipe completely dry before replacing the shelves and drawers.
• Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish. Make sure
that the doors are closed to avoid the polish getting on the magnetic door seal or inside the unit.
• The grille of the condenser at the back of the unit and the adjacent components can be
vacuumed using a soft brush attachment.

cleaning the ice bucket

Ice may clump in the ice bucket if they are not dispensed for a period of time. If this occurs, remove
all the ice and clean the ice bucket. Ice may also not come out through the dispenser if they get
stuck in the chute. If this occurs, clean the ice bucket and the chute.
Wash the ice bucket and the chute with a mild detergent, rinse well and dry thoroughly. Do not use
harsh or abrasive cleaners or solvents.
• To remove the ice bucket, lift it up then pull out slowly.
• To re-install the ice bucket:
1. Make sure the ice bucket coupler and motor coupler are at a suitable
angle to connect correctly. If not, turn the ice bucket coupler to the
right angle to match with the motor coupler.
2. Re-installation is the reverse order of removal. Make sure the
ice bucket is held firmly by the bracket.

cleaning the dispenser

Wipe the receiving base of the dispenser with dry towel regularly to avoid overflowing.
16
②
①
chute
motor
coupler
connect
ice bucket
coupler
②
①