Contents safety warnings ........................4 unpacking ..........................8 installation ........................... 9 location ..........................9 levelling the unit ....................... 9 free space requirements ....................9 installing the door handle ....................9 reversing the door swing ....................10 installing in pairs with fridge unit (optional) ..............13 cleaning before use .......................
safety warnings For your continued safety and to reduce the risk of injury or electric shock, please follow all the safety precautions listed below. • Read all instructions carefully before using the unit and keep them for future reference. • Retain the manual. If you pass the unit onto a third party, make sure to include this manual.
flammable propellant in this appliance. • Do not store bottles or glass containers in the freezer compartment. Contents can expand when frozen (fizzy drinks) which may break the bottle and damage your freezer compartment. (If applicable) • To avoid contamination of food, pay attention to the following: - opening the door for long periods can cause a significant increase of the temperature in the compartments of the appliance;...
The table below contains general guidelines on the storage of food in the refrigerator. Refrigerator location Type of food Fridge door • Foods with natural preservatives, such as jams, juices, drinks, condiments. • Do not store perishable foods. Crisper bin (salad bin) •...
WARNING • Keep ventilation openings in the unit enclosure or in the built- in structure clear of obstructions. • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. • Do not use electrical appliances inside the food storage compartments of the unit, unless they are of the type recommended by the manufacturer.
Thank you for purchasing your new Kenwood Freezer. These operating instructions will help you use it properly and safely. We recommend that you spend some time reading this installation/instruction manual in order that you fully understand all the operational features it offers.
installation installation location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated with an average room temperature of between 10°C and 43°C. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
installation reversing the door swing tools required: Philips style screwdriver / Flat bladed screwdriver / Hexagonal spanner • Ensure the unit is unplugged and empty. • To take the door off it is necessary to tilt the unit backwards. You should rest the unit on something solid, e.g.
installation 3. Remove the screws and loosen the wire from the hinge. Remove the upper hinge. Lift the door and place it on a padded surface to prevent from being scratched. 4. Remove the stopper and stop block from the bottom of the door and move them to the opposite side.
installation 7. Screw the levelling feet fix board, bottom hinge and levelling feet tightly on their new position. 8. Stand the unit. Swap the position of the wires between the left and right slots on top of the unit. 9. Reverse the upper hinge and place it on its new position.
installation 11. Reverse the upper door corner block and attach on the door. Put back the upper door cover. 12. Move the magnet cord to the opposite side and attach the corner cover. Put back the upper cover. 13. Move the door handle to the other side of the door accordingly.
installation 1. Place a connecting board at the back of both units and screw tightly. 2. Place a connecting board on top of both units and screw tightly. 3. Remove the hole cover above the levelling foot of both units. Place a connecting board and screw tightly.
installation In some cases, the door seal may be crushed after prolonged storing pressure, resulting to the door seal not able to close properly when reversed. Follow the steps below to solve the issue: • Peel off the door seal from the upper or lower corner and warm it with a hairdryer;...
operation switching on your unit 1. Connect the mains cable to the mains socket. The internal temperature of your unit is controlled by an electronic control panel on the door. 2. Press for 1 second to switch on the unit and 5 seconds to switch off the unit.
door and temperature alarm In case of door or temperature alarm, the alarm indicator will illuminate and an alarm will sound, press to deactivate the alarm. • When the freezer door is left opened for over 2 minutes, the alarm will be activated. The alarm will sound 3 times per minute and will automatically stop sounding after 10 minutes if is not pressed.
• You can use the space in the freezer most efficiently if you freeze liquids (or solids with liquids, e.g. stew) in square blocks. This is known as “Preforming”. Pour the liquid into a polythene bag which is inside a square sided container.
maintenance care when handling / moving your unit Hold the unit around its sides or base when moving it. Under no circumstances should it be lifted by holding the edges of the top surface. servicing The unit should be serviced by an authorised engineer and only genuine spare parts should be used.
Brand Kenwood Model KTF60X15 / KTF60B17 Household Appliance Category Energy Efficiency Class Energy consumption 314 kWh per year, based on standard test results for 24 hours. Actual energy consumption will depend on how the appliance is used and where it is located.
Need Help with your product? Your product is supported by Knowhow under a Trademark Licence from Fisher & Paykel Appliances Italy SpA. For help or spare parts please call us on: 0344 561 1234 The symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste.