Freezer Temperature Control - GE Monogram ZIS36 Manual

'.
MONOGRAM REFRIGERATORS
Fan Delay Thermostat
The evaporator fan delay thermostat is
mounted to the right rear of the evaporator
above the defrost thermostat.
For access to the fan delay thermostat; the
ice service shelf,- the icemaker, plenum,
and fan diffuser panel must be removed on
dispenser models - on non-dispenser models
the light shield must be removed first ...
Then, to remove the thermostat; reaching up
behind the right side of the evaporator,
dismount the top thermostat clamp by
compressing it at the bottom. (The bottom
thermostat may need to be removed first to
allow access to the top thermostat) Pull
the clamp out of the bottom mounting slot
and remove the thermostat. When
reinstalling the thermostat, use a
flashlight and mirror to locate the clamp
and mounting slot. Position the thermostat
in the clamp and push the bottom of the
clamp back into position.
Freezer Temperature Control
The temperature control for the freezer
compartment is mounted to a panel, behind
ZIS MODELS
DEPRESS
CLIP
ROTATE
TO REAR
....-1--------7!
/ / I ././ I
/ / I /./ I
rc------;---____,/" ,
I I
i
I
REMOVE
THERMOSTAT
I ....--1----' ____
I
I ....- ..(-1---1----
7 ' - - - - _ _ _ _
I ....-",,-/
/--f--r-+---J__
/(;fr-------:--71
1 ./ / \ . .
-x
/0 ,
,I /
I
r:=- . ,/ / .:' ct:'7'7\=~'jy
I
f-':-=
~~-- ,~J_\--~';;:
'T=:
==a=.,.=--// .
I
I
t [
~--1
L=-_r-1-c--;--( I
I
I 1
'
II I
I
I
I
I -
I
FREEZER
-ll ___
.J
I
I
I I
I
•
the control console, at the top rear of the
fresh food compartment. The control
capillary, covered with a vinyl sleeve, is
routed through the wall in the compartment
I I
CONTROL I i \ FREEZER I .
I I
CAPILLARY
i :
CONTROL
i
I ,
I I
PLUG
BUTTON PLENUM
divider and extends into the freezer
compartment. The exposed end of the
capillary is coiled and clamped to secure
its position in the cold air stream behind
the plenum.
For access to the freezer control; remove
the light shield, control console, knobs
and extensions, and fresh food control.
Then, remove the screws that secure the
control panel to the liner.
To replace the control, disconnect wiring
leads, and remove the two mounting screws.
Then remove the ice bucket and plastic
plug button in the plenum. This plug
button provides access to the clip holding -,
- !
the end of the cap; 11 ary.
m;;:'-;I""
-'"1,
I
Remove the screw holding the control capillary ,_'
i
~ L_~
clip and let the capillary drop down below the
~
_
~~il
plenum - uncoil the capillary - save clip. Pull the
1 ' _ ____
i1!L?
control capillary out of the sleeve and through to the
8 --------- ______
j.!1
fresh food compartment and replace the control. Use the
sle~ve
to guide the capillary back into position. Coil the
•
caPillar y 1 1/2-times at the end and place clip at top of coils.
Push the capillary
into position from rear of plenum and secure the clip. Make sure capillary is not
touching the rear liner.
- 11 -