Temperature Control; Defrost Control; Light Switches - GE ETS series Technical Service Manual

Temperature Control

1. Remove 3 screws and lower the control
console.
2. Disconnect the harness connector and
remove the control console.
Ground Ground
Wire Wire
Temperature Temperature
Control Control
Locking Locking
Tabs Tabs
3. Remove knob and clip from temperature
control.
4. Remove styrofoam duct from control console.
5. Remove capillary from plastic sheath.
Note:
• To avoid damage to capillary, it may be
necessary to remove wire connectors from defrost
control and from light socket(s).
• Temperature control knob clip will be loose when
knob is pulled from temperature control. Use care
to avoid loosing clip. During installation, clip is
installed after knob is pushed on the temperature
control.
6. Press the locking tab back and slide the
temperature control out of the control console.
7. Disconnect 3 wire leads from the temperature
control.
Wire Wire
Temperature Temperature
Leads Leads
Adjustment Adjustment
Knob Knob
GEA01172

Defrost Control

1. Remove the control console (see Temperature
Control procedure).
2. Disconnect the wiring harness connector from
the defrost control.
Locking Tabs Locking Tabs
3. Press the locking tabs back and slide the
defrost control out of the control console.

Light Switches

1. Insert a small flat screwdriver under the right
side of the light switch and release the switch
locking tab.
Light Switch Light Switch Light Switch
2. Pull the switch out, disconnect the wire leads,
and remove the switch.
– 11 –
Defrost Defrost
Control Control
Connector Connector
GEA01174
Release Tab Release Tab Release Tab
GEA01171