Installation; Mounting; Plumbing - ExcelPool Products Excelpool Salt System Installation And Operation Manual

INSTALLATION

Installation must be performed in accordance with Local NEC codes.
Preparing Pool Water: The pool's chemistry must be balanced
BEFORE activating the Excelpool System. It is recommended
that you consult a pool professional for the initial balancing each
season.
NOTE: At the beginning of each season,add metal remover
and polymer based (non-copper) algaecide to the pool, per
manufacturer's instructions. This ensures a quick, trouble free
transfer to the Excelpool System system.
Mounting the ExcelPool System Control
The Excelpool System is contained in a rain tight enclosure that
is suitable for outdoor mounting. The control must be mounted a
minimum of 5 ft (2 meters) horizontal distance (or more if local
codes require) from the pool/spa.
The control is designed to mount vertically on a flat surface
with the knockouts facing downward. Because the enclosure
also acts as a heat sink (disperses heat from inside the box), it
is important not to block the four sides of the control.
Do not mount the Excelpool System in a panel or tightly enclosed
space.

Plumbing

Ensure that the Excelpool System installation does not constitute
a cross connection with the local potable water supply. Consult
local plumbing codes.
The cell and flow switch are plumbed in the return line to the pool.
Install after (downstream) all the pool equipment (filter, heater,
solar, etc.). The kit included in the Excelpool System provides the
necessary plumbing components for:
• 2" (51mm) rigid PVC piping installation for in ground pools
• 1 1/2-1 1/4 (38-32mm) flexible hose connections for
above ground pools
19 | P a g e