Controls - ExcelPool Products Excelpool Salt System Installation And Operation Manual

POLYMERS
It is advised to use polymers (commonly sold as poly algaecide)
on salt water sanitizing systems. The poly algaecide is sold in
30% and 60% concentrations.
Application rate is 1 quart of Poly 30 (or ½ quart of Poly 60) per
15,000 gallons (60,000 liters) of pool water, per month. Apply
directly in front of the return jet.

CONTROLS

MAIN SWITCH
• AUTO: For normal operation, the Main switch should be left
in the AUTO position. In this position the Excelpool System
will produce chlorine according to the "Desired Level %"
adjustment setting for the entire filtering / pumping cycle.
• SUPER CHLORINATE: When you have an abnormally high
bather load, heavy rainfall, cloudy water conditions, or any
other condition which requires that a large amount of
purification be introduced, set the Main Switch in the SUPER
CHLORINATE position. This electronically "super
chlorinates" (shocks) the water for 24 hours (filter pump must
be on during this time) or until the power has been turned off,
whichever comes first. At the end of the super chlorination
period, be sure to put the switch back into the AUTO position.
• OFF: The OFF position prevents the Excelpool System
from energizing the electrolytic cell. In this position there is no
chlorine generation.
NOTE: In times of servicing, the OFF switch is not to be used.
To service the Excelpool System, turn power off the circuit
breaker.
12 | P a g e