ExcelPool Products Excelpool Salt System Installation And Operation Manual page 10

HOW TO ADD OR REMOVE SALT
• IN GROUND POOLS: Turn the filter pump on and add
the salt directly into the pool at the shallow end.
• ABOVE GROUND POOLS WITH MAIN DRAINS: Add
directly in front of the return jet to pool. Run the filter pump
for 24 hours with the suction coming from the main drain
(use the pool vacuum if there is no main drain) to allow the
salt to evenly disperse throughout the pool.
• ABOVE GROUND POOLS WITHOUT MAIN DRAINS:
Add directly into the pool. Brush the salt to speed up the
dissolving process - do not allow the salt to sit in a pile on
the bottom of the pool.
ON ANY POOL, DO NOT ADD SALT DIRECTLY TO THE
SKIMMERS OR DIRECTLY ONTO THE MAIN DRAIN. THIS
WILL SHUT DOWN OR SHORTEN THE LIFE OF THE CELL
DUE TO HIGH SALT CONCENTRATION AND REDUCED FLOW
TO THE PUMP.
If added incorrectly, immediately turn off Excelpool System for
24 hours with the pump and filter operating This will help to
evenly distribute the salt. The salt display may take 24 hours to
respond to the change in salt concentration.
SALT DOES NOT EVAPORATE FROM POOL
The only way to lower the salt concentration is to partially drain
the pool and refill with fresh water.
9 | P a g e