ExcelPool Products Excelpool Salt System Installation And Operation Manual page 19

ALWAYS POUR ACID INTO WATER-NEVER POUR
WATER INTO ACID. BE SURE TO WEAR PROTECTIVE
GLASSES, CLOTHING AND CHEMICAL RESISTANT
• The level of the solution in the container should just
reach the top of the cell so that the wire harness
compartment is NOT submerged. It may be helpful to coil
the wiring before immersing the cell.
• The cell should soak for FIVE minutes, then rinse with
a high-pressure garden hose.
• If any deposits are still visible, repeat soaking and
rinsing.
• Replace cell and inspect again periodically.
WINTERIZING
The Excelpool System electrolytic cell and flow detection
switch will be damaged by freezing water, similar to other
pool components that require proper winterization. In areas of
the country that experience severe or extended periods of
freezing temperatures, be sure to drain all water from the
pump, filter, and supply and return lines before any freezing
conditions occur. The electronic control is capable of
withstanding any winter weather and should not be removed.
Spring Start-Up
DO NOT turn Excelpool System on, until the pool water
chemistry has been balanced to proper levels.
GLOVES
18 | P a g e