Steps
1. Locate the touchpad on your computer.
2. Open the latch and connect the keyboard transfer cable to the system board.
3. Affix back the adhesive tapes.
4. Install the three (M2x2) screws that secure the touchpad bracket and align the bracket into the palmrest.
5. Open the latch and connect the touchpad cable into the connector.
6. Install the three (M2x2) screws that secure the touchpad.
7. Affix back the transparent adhesive tapes.
8. Open the latch and connect the keyboard transfer cable to the system board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the memory.
5. Remove the
Solid state drive
6. Remove the
WLAN
card.
7. Remove the Heatsink.
About this task
The figure indicates the location of the system board and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
computer.
Disassembly and reassembly
53