Table of Contents
Advertisement
INTRODUCTION
Thank you for purchasing a Futaba 32MZ digital proportional R/C system. This system is extremely
versatile and may be used by beginners and pros alike. In order for you to make the best use of your
system and to ly safely, please read this manual carefully. If you have any dificulties while using
your system, please consult the manual, our online Frequently Asked Questions (on the web pages ref-
erenced below), your hobby dealer.
Due to unforeseen changes in production procedures, the information contained in this manual is sub-
ject to change without notice.
Application, Export, and Modiication
1. This product is only designed for use with radio control models. Use of the product described in this
instruction manual is limited to radio control models.
2. Exportation precautions:
(a) When this product is exported, it cannot be used where prohibited by the laws governing radio
waves of the destination country.
(b) Use of this product with other than models may be restricted by Export and Trade Control Regula-
tions.
3. Modification, adjustment, and replacement of parts: Futaba is not responsible for unauthorized
modiication, adjustment, or replacement of parts on this product.
Outside North America
Please contact the Futaba importer in your region of the world to assist you with any questions, prob-
lems or service needs. Please recognize that all information in this manual, and all support availabil-
ity, is based upon the systems sold in North America only. Products purchased elsewhere may vary.
Always contact your region's support center for assistance.
Compliance Information Statement (for U.S.A.)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
(3) RF Radiation Exposure Statement (For T32MZ)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or trans-
mitter.
RF Radiation Exposure Statement (For R7108SB)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment. This equipment should be installed and operated with minimum distance 20 cm between the
radiator & your body.
The responsible party for the compliance of this device is:
Futaba Service Center
2681 Wall Triana Hwy Huntsville, AL 35824, U.S.A.
TEL 1-256-461-9399 or E-mail: contactus@futaba.com
4
＜ Introduction ＞
http://www.futabausa.com
(http://www.rc.futaba.co.jp/english)
Advertisement
Table of Contents
