Tekmar tekmarNet4 Setpoint Control 162 Wiring Brochure

- Wiring Brochure
tekmarNet ® 4 Setpoint Control 162
1 2
Information Application
Brochure
Choose controls Design your
to match mechanical
application applications
Overview
The following brochure describes how to wire the tekmarNet
for heat or cool and the other for a recirculation pump. The 162 has one sensor input.

Table of Contents

Definitions .......................................................................2
Rough-In Wiring .............................................................2
Remove the Wiring Cover ..............................................3
Mounting the Setpoint Control .......................................3
Wiring Symbols ...............................................................3
3
Rough In
Brochure Wiring
Rough-in
wiring
instructions
tN4 Network
24 V (ac) Power
Sensor Input
4
Wiring
Brochure
Wiring and
installation of
specific control
® 4 (tN4) Setpoint Control 162. The 162 has two outputs, one
tN4 Setpoint Control 162
One Stage Heat / Cool
Power:
Relays:
/
DIP
Switches
Electrical Drawings ......................................................3-5
Wiring the Setpoint Control .............................................6
Troubleshooting the Wiring .............................................7
Testing the Wiring ...........................................................7
Technical Data ................................................................8
1 of 8
5 6
Data
Brochure
Control settings
Record settings &
and sequence of
wiring details for
operation
future reference
Relay
Jumper
Contacts
Cut jumper to
isolate relay
Feb 2006
Lot 1948
Meets Class B:
Canadian ICES
FCC Part 15
24 V ±10% 50/60 Hz 3.2 VA
24 V (ac) 2 A
© 2008
W 162
12/08
Job
Record
W 162 - 12/08