Removal Of Parts For Cleaning/Sanitizing; Top Cover - Manitowoc SM Series Installation, Operation And Maintenance Manual

Maintenance

Removal of Parts for Cleaning/Sanitizing

1. Turn off the electrical and water supply to the ice
machine.
n
Disconnect electric power to the ice machine before
proceeding with any of the following procedures.
2. Remove all ice from the bin.
3. Remove the components that must be cleaned
and sanitized. See the following pages for removal
procedures for these parts.
n
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or Sanitizer.
4. Soak the removed part(s) in a properly mixed solution of
cleaner.
Solution Type Water
Cleaner 1 gal. (4 l)
Sanitizer 2 gal. (8 l)
5. The cleaner will foam; once the foaming stops use a soft-
bristle nylon brush, sponge or cloth (NOT a wire brush)
to carefully clean the parts.
,
Do not mix Cleaner and Sanitizer solutions together. It
is a violation of Federal law to use these solutions in a
manner inconsistent with their labeling.
,
Do not immerse the water pump motor in the cleaning or
sanitizing solution.
6. Thoroughly rinse all the parts with clear water.
7. Soak the removed parts in a properly mixed solution of
sanitizer for 5 minutes.
8. Use a soft-bristle nylon brush, sponge or cloth (NOT a
wire brush) to carefully sanitize the parts.
9. Use the sanitizing solution and a sponge or cloth to
sanitize (wipe) the interior of the ice machine and bin.
10. Rinsing is not required when using Manitowoc Sanitizer.
11. Install the removed parts.
12. Turn on the water and electrical supply
24
Warning
Warning
Mixed With
8 oz (240 ml) cleaner
1 oz (30 ml) sanitizer
Caution
Caution

TOP COVER

1. Disconnect power to the ice machine.
2. Remove two back screws.
3. Slide top cover backward slightly and lift cover off.
Part Number 000001590 Rev03 11/19
Section 4
1
2